***draft*** Project Preview:

Submersible Sump Pumps

K2 Sump Pumps are available in a variety of different configurations:

Materials — Cast Iron, Cast Aluminum, Stainless Steel and Thermoplastic
Horsepower — The amount of power the pump produces to remove water at different flow rates
Switch Types — Piggyback and Direct-in Vertical and Tethered Switches, Snap Action Switches
The right combination of these features will meet the requirements of each unique sump installation.

NEED TO KNOW

SUMP REQUIREMENTS

Pit must be covered. It is usually 10-18’’ in diameter and 14-18’’ deep. See pump owner’s manual for pit size needed.

Install on a hard surface: brick, cement, or concrete block; no sand, clay, or gravel.

Unless otherwise noted:

Models with a tethered float switch require a sump pit at least 14’’ in diameter.

Models with a vertical float switch require a sump pit at least 10’’ in diameter.

WHEN YOU’RE DONE

<<<should look like this>>>

SKILLS REQUIRED

TBD

TBD

TBD

TYPICAL TOOLS & MATERIALS NEEDED

Login

Lost your password?